Delta ASDA-M Series

ASDA-M Chapter 8 Parameters
Revision December, 2014 8-99
Settings：
 Semi-auto Setting:
1: It means the inertia estimation in semi-auto mode is
completed. The inertia value can be accessed via P1-37.
0: 1. When the display is 0, it means the inertia adjustment is
not completed and is adjusting.
2. When the setting is 0, it means the inertia adjustment is
not completed and is adjusting.
P2-34 SDEV The Condition of Overspeed Warning
Address: 0244H
0245H
Parameter
Attribute：
Parameter for individual axis
Related Section: -
Operational
Interface：
Panel / Software Communication
Default：
5000
Control
Mode：
S
Unit：
r/min
Range：
1 ~ 5000
Data Size：
16bit
Format：
DEC
Settings：
The setting of over speed warning in servo drive erro display
(P0-01)
P2-35 PDEV
Condition of Excessive Position
Control Deviation Warning
Address: 0246H
0247H
Parameter
Attribute：
Parameter for individual axis
Related Section: -
Operational
Interface：
Panel / Software Communication
Default：
3840000
Control
Mode：
PT／PR
Unit：
Pulse