Appendix B Maintenance and Inspection ASDA-M
B-2 Revision December, 2014
To avoid the electromagnetic brake losing efficacy, please check if
stop function and circuit break function can work normally.
If the peripheral devices are interfered by the electronic
instruments, please reduce electromagnetic interference with
devices.
Please make sure the external voltage level of the servo drive is
correct.
Inspection before
running the servo
drive
(has already applied
to the power)
The encoder cable should avoid excessive stress. When the
motor is running, please be ensured the cable is not frayed or
over extended.
Please contact with Delta if there is any vibration of the servo
motor or unusual noise during the operation.
Make sure the setting of the parameters is correct. Different
machinery has different characteristic, please adjust the
parameter according to the characteristic of each machinery.
Please reset the parameter when the servo drive is in the status of
SERVO OFF, or it may cause malfunction.
When the relay is operating, make sure it can work properly.
Check if the power indicator and LED display works normally.
Maintenance
Please use and store the product in a proper site.
Periodically clean the surface of the servo drive and servo motor so as to avoid the
dust and dirt.
Do not disassemble any mechanical part when in maintenance.
Periodically clean the ventilation ports of the servo drive and do not use the product in
a high-temperature site for a long time so as to avoid the malfunction.
To Next Page
Loading...
Need help?
General
