Chapter 12 Descriptions of Parameter SettingsC2000 Plus
12.1-09-7
09-70
Communication Card Address (for DeviceNet or PROFIBUS)
Default: 1
Settings DeviceNet: 0–63
Profibus-DP: 1–125
09-71
Communication Card Speed Setting (for DeviceNet)
Default: 2
Settings Standard DeviceNet:
0: 125 Kbps
1: 250 Kbps
2: 500 Kbps
3: 1 Mbps (Delta only)
Non-standard DeviceNet: (Delta only)
0: 10 Kbps
1: 20 Kbps
2: 50 Kbps
3: 100 Kbps
4: 125 Kbps
5: 250 Kbps
6: 500 Kbps
7: 800 Kbps
8: 1 Mbps
09-72
Additional Settings for Communication Card Speed (for DeviceNet)
Default: 0
Settings
0: Standard DeviceNet
In this mode, the baud rate can only be 125 Kbps, 250 Kbps or 500 Kbps
in standard DeviceNet speed
1: Non-standard DeviceNet
In this mode, DeviceNet baud rate can be same as that for CANopen
(0–8).
Use this parameter with Pr.09-71.
0: The baud rate can only be set to 125 Kbps, 250 Kbps and 500 Kbps as a standard DeviceNet
speed.
1: The DeviceNet communication rate can be the same as that for CANopen (setting 0–8).
09-74
Communication Card Control Flag
Default: 1
Settings bit0: set the EDS identity definition of EIP card
bit0 = 0: identify EIP card by the drive’s family
bit0 = 1: identify EIP card by the drive’s series
This parameter defines the EDS identification method of EIP cards. The definition is as follows: