Delta C2000 Plus Series - Page 661

Chapter 12 Descriptions of Parameter SettingsC2000 Plus
12.1-09-8
bit0: EDS identity definition of EIP card
 bit0 = 0: Identify EIP card by the drive’s family, for example, M300 family and C2000 family.
 bit0 = 1: Identify EIP card by the drive’s series, for example, C2000, CH2000, C2000-HS,
CP2000…etc.

09-75
Communication Card IP Configuration (for EtherNet)
Default: 0
Settings 0: Static IP
1: Dynamic IP (DHCP)
 0: Set the IP address manually.
 1: IP address is dynamically set by the host controller.

09-76
Communication Card IP Address 1 (for EtherNet)

09-77
Communication Card IP Address 2 (for EtherNet)

09-78
Communication Card IP Address 3 (for EtherNet)

09-79
Communication Card IP Address 4 (for EtherNet)
Default: 0
Settings 0–65535
 Use Pr.09-76–09-79 with a communication card.

09-80
Communication Card Address Mask 1 (for EtherNet)

09-81
Communication Card Address Mask 2 (for EtherNet)

09-82
Communication Card Address Mask 3 (for EtherNet)

09-83
Communication Card Address Mask 4 (for EtherNet)
Default: 0
Settings 0–65535

09-84
Communication Card Gateway Address 1 (for EtherNet)

09-85
Communication Card Gateway Address 2 (for EtherNet)

09-86
Communication Card Gateway Address 3 (for EtherNet

09-87
Communication Card Gateway Address 4 (for EtherNet)
Default: 0
Settings 0–65535

09-88
Communication Card Password (Low Word) (for EtherNet)

09-89
Communication Card Password (High Word) (for EtherNet)
Default: 0
Settings 0–99

09-90
Reset Communication Card (for EtherNet)
Default: 0
Settings 0: Disabled
1: Reset to default