Delta DVP-PLC User Manual

2 Functions of Devices in DVP-PLC
DVP-PLC Application Manual
2-76
Device No. Cleared Device
M1032
 Contact status of M and S for latched
 Contact and timing coil of accumulative timer T
 Contac and timing coil of high-speed counter C for latched
 Present value register of D for latched
 Present value register of accumulative timer T
 Present value register of high-speed counter C for latched
Function Group
Output Latched During STOP
Number
M1033
Contents:
When M1033 = On and PLC goes from “RUN” to “STOP”, the On/Off status of output will be ratained.
Assume the output contact load of the PLC is a heater, when PLC switches from RUN to STOP, the status of the
heater will be retained. After the PLC program is modified, the PLC will RUN again.
Function Group
All Output Y Inhibited
Number
M1034
Contents:
When M1034 = On, all Y outputs will turn “Off”.
M1034
all outputs inhibited
Function Group
RUN/STOP Switch
Number
M1035, D1035
Contents:
1. When M1035 = On, EH/EH2/SV series MPU will determine the content (K0 ~ K15) in D1035 to enable input
points X0 ~ X17 as the RUN/STOP switch.
2. When M1035 = On, SA/SX/SC series MPU will enable the input point X7 (in SA), X3 (in SX) and X5 (in SC) as
the RUN/STOP switch.
Function Group
Detecting Speed of X0 ~ X5
Number
M1036
Contents:
1. For SC_V1.4 and above, SPD can detect the speed of X0 ~ X5 at the same time. The total bandwidth is 40KHz.
2. Program example:

Delta DVP-PLC Specifications

General

Manufacturer	Delta Electronics
Model	DVP-PLC
Category	Controller
Humidity	5% to 95% RH, non-condensing
Programming Language	Ladder Diagram (LD), Instruction List (IL), Sequential Function Chart (SFC)
CPU Type	Various, depending on the specific model within the DVP series (e.g., ES2, EX2, SX2, SA2, EH3, etc.)
Operating Temperature	Typically 0°C to 55°C (32°F to 131°F)
Storage Temperature	Typically -25°C to 70°C (-13°F to 158°F)