EasyManuals Logo

Delta DVP-PM Series User Manual

Delta DVP-PM Series
561 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #153 background imageLoading...
Page #153 background image
5 Categories and Use of Basic Application Instructions
DVP-PM Operation Instruction
5-16
Device
Contact state
before CJ execution
Contact state
during CJ execution
Output coil state
during CJ execution
M1, M2, M3 OFF
M1, M2, M3 OFF t
ON
Y1
*1
, M20, S1 OFF
Y, M, S
M1, M2, M3 ON
M1, M2, M3 ON t
OFF
Y1
*1
, M20, S1 ON
M4 OFF M4 OFF t ON
Timer T0 is not enabled.
M4 ON M4 ON t OFF
Timer T0 immediately stops and is
latched. When M0 ON t OFF, T0 will be
reset.
M6 OFF M6 OFF t ON
Timer T240 is not enabled.
10ms Timer
M6 ON M6 ON t OFF
Timer T240 immediately stops and is
latched. When M0 ON t OFF, T240 will
be reset.
M7, M10 OFF
M10 is ON/OFF
triggered
Counter C0 stops
C0 ~ C234
M7 OFF, M10 is
ON/OFF triggered
M10 is ON/OFF
triggered
Counter C0 stops and latched. When M0
is OFF, C0 resumes counting.
M11 OFF M11 OFF t ON
Application instructions will not be
executed.
Application
instruction
M11 ON M11 ON t OFF
The skipped application instruction will
not be executed but API 53~59, API
157~159 keep executing.
*1: Y1 is dual output. When M0 is OFF, Y1 is controlled by M1. When M0 is ON, Y1 is controlled by M12.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Delta DVP-PM Series and is the answer not in the manual?

Delta DVP-PM Series Specifications

General IconGeneral
BrandDelta
ModelDVP-PM Series
CategoryController
LanguageEnglish

Related product manuals