Chapter 3 Featured Functions
Local Authentication Server Configuration
Description Factory Default
User Name
Enter a user name. None
Password
Enter a password. Passwords should consist of 1 through 20
alphanumeric characters and are case-sensitive. The password is
displayed as asterisks (*).
None
Permission
Specify whether the user is allowed or denied interface access:
Allow: Allows the user access to the interface.
Deny: Denies the user access to the interface.
None
Auth-TimeOut (secs)
Specify the period in seconds after which the server authentication
times out and the user needs to be reauthenticated by the local
authentication server. Enter a period between 1 and 7200 seconds.
After the supplicant is authorized, the server authentication time-out
period overrides the reauthentication period that is configured for the
individual interface (see Port Authentication page). Leave the
Auth-TimeOut field blank to use the reauthenticaiton period that is
configured for the individual interface.
Note:
If you enable server reauthentication after a user has
already been authenticated by the server, the server
authentication time-out period does not take effect, and the
reauthentication period value that is configured for the
individual interface is used.
Note:
If server reauthentication is enabled, a user is authenticated
by the server, and then you change the authentication
time-out period, the new authentication time-out period
takes effect after the next reauthentication by the server.
0
Port List
Specify the interfaces for which authentication needs to be obtained.
Leave the field blank to include all interfaces.
0/1-10
3-87
To Next Page
Loading...