Delta NT Series - Page 82

77
Ultron NT Series

z
The UPS ID shown on the Start Display (see Figure 6-2) is for application of
the RS-485 interface and monitoring software (UPSentry 2012). It can be set up
right from the LCD control panel.
To leave the “UPS ID Setting” page, press the “ ” and “ ” buttons simultaneously to go
back to the “Parameter Setting” menu.
5-7. Press the “ ” or “ ” button to choose “Display Setting” and press the “ ”
button to enter the “Display Setting” page.

z
Press the
“
” or “ ”
button to set up
the brightness and contrast of the LCD
and press the “
” button to confirm
the setting.
Brightness
ContrastǺ
5
ɥ烉為
ɧ烉炼

z
In order to extend the LCD lifetime,
press the
“
” or “ ”
button to set up
the screen saver and press the “
”
EXWWRQWRFRQ¿UPWKHVHWWLQJ
Screen
SaverǺ
3 Min
ɥ烉為
ɧ烉炼
To leave the “Display Setting” page, press the “ ” and “ ” buttons simultaneously to
go back to the “Parameter Setting” menu.
5-8. Press the “ ” o r “ ” button to choose “Language Setting” and press the
“
” button to enter the “Language Setting” page.

z
Press the
“
” or “ ”
button to choose
“Chinese” or “English” and press the
“
´EXWWRQWRFRQ¿UPWKHVHWWLQJ
ÆChinese
English