Need help?Do you have a question about the DEMA 400 Series and is the answer not in the manual?
Configures settings for phase and earth overcurrent, thermal overload.
Configures settings for over/under voltage and negative sequence voltage.
Configures settings for low, over, and rate-of-change frequency protection.
Configures settings for directional active/reactive over/under power.
Protects against overcurrents in phases.
Protects against earth overcurrents.
Starts when total active power reading exceeds the starting value.
Starts when total active power reading falls below the starting value.
Starts when total reactive power reading exceeds the starting value.
To Next Page
General