Denon AVC-A1SR

18
ENGLISH
5
Enter the setting.
The Ext. In Setup reappears.
Setting the Digital Multi Ch In
1
2
3
Select “Digital Multi Ch In” on the System
Setup Menu screen, then press jog stick
“ENTER”.
To set, select “Ye s” and press jog stick
“ENTER”.
DENON Link setting :
Set this when connecting a Denon DVD player using the Denon Link
terminal.
Set to “ON” if you want to use the terminal, “OFF” if you do not want to use it.
When set to “ON”, also set the playback input when there is no digital signal.
ANALOG: The analog input of the input source assigned to Denon Link is played.
EXT-1: The EXT.IN-1 input is played.
EXT-2: The EXT.IN-2 input is played.
Digital Ext. In setting :
This is set for the Digital Ext. In input using the Coaxial 1 to 4 inputs.
When “ON” was selected at “Digitl Ext. In”, set the surround back channel input.
If you do not want to use the surround back channel ........NOT USED
If you do want to use the surround back channel, set according to the specifications of the connected
player.
Select “DENON Link” (using the up and down
cursor buttons) then select ON or OFF (using
the left and right jog stick).
Select “Digital Ext.In” (using the up and down cursor buttons)
then select ON or OFF (using the left and right jog stick).
When set to “ON”, the four terminals (Coaxial 1 to 4) are
assigned to the desired input source as a single digital
multichannel input.
When set to “OFF” the four terminals (Coaxial 1 to 4) are
assigned to individual input sources.
4
Enter the setting.
The System Setup Menu reappears.
• Use this to turn the on-screen display (messages other than the menu screens) on or off.
Setting the on-screen display (OSD)
1
At the System Setup Menu select “On Screen Display”.
2
Switch to the On Screen Display screen.
3
Select “ON” or “OFF”.
4
Enter the setting.
The System Setup Menu reappears.
The system setup settings can be locked so that they cannot be changed easily.
Protecting the setting
1
2
3
Select “Setup Lock” on the System Setup Menu screen.
Press jog stick “ENTER” to switch to the Setup Lock screen.
Select “ON”, to lock the system setup settings.
NOTE:
• When playing sources using the DENON LINK terminal, also connect the analog external input terminal
(EXT-1) (see page 7), and set the “No Digital Signal” setting to “EXT-1”.