Denon AVC-A1SR

ENGLISH
33
B To select Bass or
Treble.
Tone control setting
• Use the tone control setting to adjust the bass and treble as desired.
1
Display the surround
parameter screen on the
monitor.
The screen for the
selected surround mode
appears.
“TONE” cannot be
selected in the Direct or
Home THX Cinema mode.
2, 3, 4, 5
(Remote control unit)
2
Press the CURSOR/PAGE
button to highlight the display,
then use the jog stick to set
the parameters.
Select “TONE”.
(Remote control unit)
3
Switch to the Tone Control
screen.
(Remote control unit)
1, 4
4
If you do not want the tone to be adjusted,
set “Tone Defeat” to “ON”. (See page 21.)
(Remote control unit)
(Remote control unit)
5
Enter the setting.
The surround menu screen re-appears.
(Remote control unit)
6
Press the CURSOR/PAGE button so that the display is no longer highlighted, then press
the “SURR. PARA” button to complete the setting.
(Remote control unit)
Surround parameters t
EFFECT:
This parameter turns the effect signals with multi surround mode speaker effects on and off in the WIDE
SCREEN mode. When this parameter is turned off, the SBL and SBR channel signals are equivalent to the
SL and SR channels, respectively.
LEVEL:
This parameter sets the strength of the effect signals in the WIDE SCREEN mode. It can be set in 15 steps,
from “1” to “15”. Set this to a low level if the positioning or phase of the surround signals sounds unnatural.
SB CH OUT:
“ON” ......................Playback is conducted using the surround back speaker.
“OFF”.....................Playback is conducted without using the surround back speaker.
NOTE: This operation can be performed directly using the “6.1/7.1 Surround” button on the main unit’s panel.
ROOM SIZE:
This sets the size of the sound field.
There are five settings: “small”, “med.s” (medium-small), “medium”, “med.l” (medium-large) and “large”.
“small” recreates a small sound field, “large” a large sound field.
EFFECT LEVEL:
This sets the strength of the surround effect.
The level can be set in 15 steps from 1 to 15. Lower the level if the sound seems distorted.
DELAY TIME:
In the matrix mode only, the delay time can be set within the range of 0 to 300 ms.
TONE CONTROL:
This can be set individually for the separate surround modes other than Direct and Home THX Cinema.
B To set the level.
2 Surround modes and parameters
Signals and adjustability in the different modes
Parameter (default values are shown in parentheses)Channel output
SURROUND
L/R
CENTER FRONT L/R
SURROUND
BACK L/R
SUB-
WOOFER
SB CH OUT
(MODE)
When playing Dolby Digital and DTS signals
D. COMP LFE AFDM
C (0dB)
E
C
(0dB)
E
C
(0dB)
C (0dB)
C (0dB)
C (0dB)
C (0dB)
C (0dB)
C (0dB)
C (0dB)
C (0dB)
C (0dB)
C (0dB)
C (0dB)
C (0dB)
PURE DIRECT, DIRECT
MULTI CH DIRECT
STEREO
MULTI CH IN
WIDE SCREEN
HOME THX CINEMA
DOLBY PRO LOGIC II
DOLBY DIGITAL
DTS SURROUND
DTS NEO:6
5CH/7CH STEREO
SUPER STADIUM
ROCK ARENA
JAZZ CLUB
CLASSIC CONCERT
MONO MOVIE
MATRIX
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
E
B
E
B
B
B
B
B
B
B
B
B
B
B
B
B
B
E
B
E
B
B
B
B
B
B
B
B
B
B
B
B
B
B
E
B
E
B
B
B
B
B
B
B
B
B
B
B
B
B
B
B
B
B
B
B
B
B
B
B
B
B
B
B
B
B
B
B
C
(OFF)
E
C
(OFF)
E
C
(OFF)
C (OFF)
C (OFF)
C (OFF)
C (OFF)
C (OFF)
C (OFF)
C (OFF)
C (OFF)
C (OFF)
C (OFF)
C (OFF)
C (OFF)
E
E
E
E
E
C
C
C
C
C
E
E
E
E
E
E
E
E
C
E
C
C
C
C
C
C
C
C
C
C
C
C
C
C
Mode
C : Signal / Adjustable
E : No signal / Not adjustable
B : Turned on or off by speaker configuration setting
C : Able
E : Unable
NOTE:
The bass and treble can be adjusted within a range of -12 dB to +12 dB, and they are set to the maximum value
among the adjustment values of the individual controls.