NOTE
• Insert the AC plugs securely. Incomplete connections could cause
noise.
• Only use the AC outlet to plug in audio equipment. Do not use
them as power supplies for hairdryers or anything other than audio
equipment.
Wait until all connections have been completed before connecting the
power cord.
To household
power outlet
(AC 230 V, 50 Hz)
Power cord
(supplied)
Connecting the Power Cord
Connection to the AC outlet
• This outlet supply power to external
audio devices.
• The power supplied from this outlet turns
on and off together with the set’s power
switch.
• Audio equipment with a total power
consumption of 100 W (0.43 A) can be
connected.
Turning the Power On (vpage 48)
Once Connections are
Completed
Menu Operations
With the AVR-2809, settings and operations for most functions can be
performed by operating while looking at the menus displayed on the
monitor screen.
1
Press MENU.
The menu is displayed.
b To operate from the main remote control unit, be sure to set the
remote control unit to the AMP mode.
2
Press ui to select the item you want to set, then
press ENTER.
3
Press ui again to select the item you want to set,
then press ENTER.
4
To change the setting:
Press ui to select the item you want to change, then
press o p to change the setting.
b To return to the previous item, press RETURN.
b Select “Default Yes”, then press o to reset to the default
setting.
5
Press ENTER to enter the setting.
6
Press MENU to fi nish.
Operations
The same operation is possible on the main unit or main remote
control unit.
When MENU is pressed, the settings made up to that point are entered
and the settings menu screen turns off.
Getting Started Connections Setup Playback Remote Control Multi-zone Information Troubleshooting
ENGLISH
Specifi cations
Button located on both the main unit
and the remote control unit
BUTTON
Button only on the main unit
<BUTTON>
Button only on the remote control unit
[BUTTON]
Symbols used to indicate buttons in this manual
To Next Page
Loading...
Need help?
General
