Getting Started Connections Setup Playback Multi-zone Information Troubleshooting
ENGLISH
Specifications
MODE SELECTOR
Remote ID
AMP (MAIN) iPod
NET/TU
( )
1
(Default)
81001 72815 62863
2 82001 72816 62275
3 83001 72817 62276
4 84001 72818 62277
3
Refer to the table at the below, and use [NUMBER] to
input the 5-digit number corresponding to the remote
ID to be changed.
The signal transmission indicator flashes twice.
4
Press [NET/TU] (
mode) or [iPod] to select the
mode to be set.
5
Repeat steps 2 to 4 to set the remote IDs for all
modes.
NOTE
• When changing a setting, be sure to set the same remote ID as the
AVR-2809’s (vpage 33).
• When changing the AMP mode’s remote ID, also change the “NET/
TU” and “iPod” remote ID at the same time.
4
Press the button to be set.
The main remote control unit’s display turns off.
b If a button that cannot be learned is pressed, the signal transmission
indicator lights but the signal is not learned.
5
Point the main remote control units directly at each
other and press and hold the button on the other
device’s remote control unit that you want to learn.
Once learning is completed normally, the display lights and the
signal transmission indicator flashes twice.
b If you want to learn other buttons, repeat steps 4 and 5.
b The mode can be switched by pressing [MODE SELECTOR].
b The signal transmission indicator lights once for a long time if
learning was not possible
6
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice and the setting
is completed.
• With some remote control units, the signals cannot be learned or the
device will not operate properly even when the signals have been
learned. In this case, use the device’s own remote control unit.
• Learned buttons have priority over the preset memory. If you no
longer need the learned setting, reset the learning function (vpage
61).
NOTE
• [HOME] cannot be learned.
• Do not learn any remote control signals at [RC SETUP].
• The AMP, ZONE2, ZONE3, ZONE4 and SYSTEM CALL modes
cannot be learned.
Setting the Remote ID
When using multiple DENON AV receivers in the same room,
make this setting so that only the desired AV receiver operates.
1
Press [AMP] to set the main remote control unit to the
AMP mode.
2
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice.
Learning Function
If your AV devices are of a brand other than DENON or if they
cannot be operated with the preset memory function, their remote
control signals can be transfered to stored in the AVR-2809’s main
remote control unit.
1
Press [MODE SELECTOR] for the device you want to
set.
2
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice.
3
Press [9], [7] and [5], in that order.
The signal transmission indicator flashes twice and the learning
mode is set.
Other device’s
remote control unit
AVR-2809’s main remote
control unit (RC-1102)
Remote Control
To Next Page
Loading...
Need help?
General
