EasyManuals Logo

Denon AVR-4800 User Manual

Denon AVR-4800
69 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
4
2 INTRODUCTION
2 ACCESSORIES
Thank you for choosing the DENON AVR-4800 Digital Surround A / V receiver. This remarkable component has been engineered to provide superb
surround sound listening with home theater sources such as DVD, as well as providing outstanding high fidelity reproduction of your favorite music
sources.
As this product is provided with an immense array of features, we recommend that before you begin hookup and operation that you review the
contents of this manual before proceeding.
TABLE OF CONTENTS
Check that the following parts are included in addition to the main unit:
1
BEFORE USING
2
CAUTIONS ON INSTALLATION
Pay attention to the following before using this unit:
Moving the set
To prevent short circuits or damaged wires in the connection
cords, always unplug the power cord and disconnect the
connection cords between all other audio components when
moving the set.
Before turning the power switch on
Check once again that all connections are proper and that there are
not problems with the connection cords. Always set the power
switch to the standby position before connecting and
disconnecting connection cords.
Store this instructions in a safe place.
After reading, store this instructions along with the warranty in a
safe place.
Note that the illustrations in this instructions may differ from
the actual set for explanation purposes.
Noise or disturbance of the picture may be generated if this unit or
any other electronic equipment using microprocessors is used near a
tuner or TV.
If this happens, take the following steps:
Install this unit as far as possible from the tuner or TV.
Set the antenna wires from the tuner or TV away from this unit’s
power cord and input/output connection cords.
Noise or disturbance tends to occur particularly when using indoor
antennas or 300 /ohms feeder wires. We recommend using
outdoor antennas and 75 /ohms coaxial cables.
For heat dispersal, leave at least 10 cm of space between the
top, back and sides of this unit and the wall or other
components.
z
Before Using ..............................................................................................4
x
Cautions on Installation..............................................................................4
c
Cautions on Handling .................................................................................5
v
Features......................................................................................................5
b
Connections.........................................................................................6~15
n
Part Names and Functions.................................................................16, 17
m
Setting up the system .......................................................................18~30
,
Remote Control Unit..........................................................................31~39
.
Operation ...........................................................................................39~45
⁄0
Surround.............................................................................................46~52
⁄1
DENON Original Surround Modes.....................................................53~56
⁄2
Listening to the Radio……………………………………………………57~59
⁄3
Last Function Memory.............................................................................59
⁄4
Initialization of the Microprocessor.…………………………………………59
⁄5
Troubleshooting..………………………………………………………………60
⁄6
Additional Information……………………………………………………61~68
⁄7
Specifications .…………………………………………………………………69
q Operating instructions…..1 w Warranty ( for North America model only )………...........1 e Service station list…….....1 r AC cord.................……1
t Remote control unit y R6P/AA batteries….....2 u AM loop antenna…...1 i FM indoor antenna…........1 o FM antenna adaptor….1
(RC-869)…………………..1
r tyuio
10 cm or more
wall
10 cm or more

Other manuals for Denon AVR-4800

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-4800 and is the answer not in the manual?

Denon AVR-4800 Specifications

Power Amplifier IconPower Amplifier
stereo rated output125 W + 125 W (8 Ω/ohms, 20 Hz ~ 20 kHz with 0.05% T.H.D.)
surround rated output125 W x 5 ch (8 Ω/ohms, 1 kHz with 0.7% T.H.D.)
dynamic power170 W x 2 ch (8 Ω/ohms), 270 W x 2 ch (4 Ω/ohms), 350 W x 2 ch (2 Ω/ohms)
Analog Audio IconAnalog Audio
input sensitivity / input impedance200 mV / 47 kΩ/kohms
frequency response10 Hz ~ 100 kHz: +0, –3 dB (DIRECT mode)
S/N ratio105 dB (DIRECT mode)
Digital Audio IconDigital Audio
D/A output rated output2 V (at 0 dB playback)
total harmonic distortion0.005% (1 kHz, at 0 dB)
S/N ratio105 dB
Phono Equalizer IconPhono Equalizer
input sensitivity2.5 mV
RIAA deviation±1 dB (20 Hz to 20 kHz)
signal-to-noise ratio74 dB (A weighting, with 5 mV input)
Video IconVideo
standard video jacks input/output level and impedance1 Vp-p, 75 Ω/ohms
S-video jacks input/output level and impedanceY signal — 1 Vp-p, 75 Ω/ohms; C signal — 0.286 Vp-p, 75 Ω/ohms
color component video terminal input/output level and impedanceY signal — 1 Vp-p, 75 Ω/ohms; Cb signal — 0.7 Vp-p, 75 Ω/ohms; Cr signal — 0.7Vp-p, 75 Ω/ohms
Tuner IconTuner
receiving range87.5 MHz ~ 107.9 MHz, 520 kHz ~ 1710 kHz
usable sensitivity1.0 µV (11.2 dBf), 18 µV
signal to noise ratio (IHF-A)MONO 80 dB, STEREO 75 dB
General IconGeneral
power supplyAC 120 V, 60 Hz
power consumption10.9 A
maximum external dimensions434 (W) x 181 (H) x 494 (D) mm (17-3/32” x 7-1/8” x 19-29/64”)
Remote Control Unit IconRemote Control Unit
batteriesR6P/AA Type (two batteries)
external dimensions70 (W) x 215 (H) x 24 (D) mm (2-3/4” x 8-15/32” x 15/16”)
weight200 g (Approx. 7 oz) (including batteries)

Related product manuals