[II Backing up the current settings
Wrth the RC-8000, the current settings can be backed up.
When you back up the settrngs, the settings are not lost even when the RESET button (page 4) is pressed or the
batteries are replaced.
Press the “SETUP” icon in the icon display section for at least 3 seconds to display the setup screen.
Press the “User Backup” button on the “Setup 3/4” page to display the confirmation screen, then press the
“Yes” button. The current settings of the RC-8000 are backed
up
I21 Making the sound settings
Here, set the sound that is made when buttons are
pressed. (By default, this IS set to “ON”.)
When this is set to “ON”, a sound is produced each
trme a button IS operated. When set to “OFF”, no
sound is produced when buttons are pressed.
Press the “SETUP” Icon rn the Icon drsplay sectron
for at least 3 seconds to display the setup screen.
Press the “Sound ON” button on the “Setup 4/4”
page to switch the settrng to “OFF”.
The display changes each trme the button is
pressed. The displayed setting is the current
settrng
[31 Setting the liquid crystal display’s auto off time
With the RC-8000, the liquid crystal display
automatrcally turns off If no buttons are pressed
wrthin a specrfic amount of time.
To make the batteries last longer, we recommend
that you do not set thus time any longer than
necessary
Press the “SETUP” Icon in the icon display section
for at least 3 seconds to display the setup screen.
Press the “LCD 10s” button on the “Setup 4/4”
page. The button switches to a half-tone dot mesh.
Now use the A and V buttons to set the auto off
time. The trme can be set between 1 and 60
seconds in steps of 1 second.
III
Calibration
To Next Page
Loading...
Need help?
General
