@ Once the button is successfully learned, the preset memory search
operation starts.
Once the search operation is successfully completed, a list of the preset
memory codes is displayed.
Select the code and check that the device operates properly.
Continue the procedure as described in section “Changing the preset
memory of preset devices” on page 12.
NOTES:
l
If the corresponding preset memory is not found with the search
operation, “NONE” is set automatically.
l
A manufacturer (brand) other than the manufacturer (brand) of Your
remote control unit may be displayed. If the remote control unrt works
with the displayed manufacturer’s codes, use it as such, without
worrying about the name of the manufacturer.
Screen 0
0
8 RF TRANSMISSION FUNCTION
RF transmission is possible when the K-8000 is used in combination with the separately sold RC-8001 ST charger
base station.
For instructions, refer to the RC-8001ST’s operating instructions.
q
FACTORY DEFAULT SETTINGS
Registered device:
AVAMP TUNER, TV, DVD, VCR, CD, CDR. TAPE, SYS. CALL, SETUP
LCD off (LCD) trme:
10 seconds
Back light off (Light) time:
5 seconds
Sound setting (Sound):
ON
q
SPECIFICATIONS
Dimensions:
Mass:
Battery service life:
Distance:
Angle:
Accessories:
96 mm (width) x 38 mm (height) x 168.5 mm (depth)
(3-25/32” x l-1/2” x 6-41/64”)
242 g (8.5 oz) (not including batteries)
Approx. 3 months (under standard usage conditions)
Approximately 7 meters (22 feet)
Up to 30 degrees
LR6 (AA size1 alkaline batterres
.4
Operating instructions .l
Service station list .l
Warranty * .I
* When the RC-8000 is acqurred as an accessory rnculded wrth the AVR-5800, there
is no separate warranty for the RC-8000. (The warranty is only for the AVR-5800.)
% For purposes of improvement, specifications and design are subject to change without notice
32
To Next Page
Loading...
Need help?
General
