3
0
Select “Yes” for Start.
“Search” flashes on the screen and searching begins.
“Completed” appears once searching is completed.
CM
The display automatically switches to screen.
The system setup settings can be locked so that they cannot be changed easily.
1
Select “Setup Lock” on the System Setup Menu screen
r
System Setup Menu
0
Audio Delay
Multi Zone Control
Auto Surround Mode
Ext. In Setup
Digital Multi Ch In
On Screen Display
Auto Tuner Presets
uSetup Lock
2
NII-
Press jog stick “ENTER” to switch to the Setup Lock screen
3
Select “ON”, to lock the system setup settings.
Setup Lock
MI-
Press jog stick “ENTER” to finalize the setting and exit the system setup mode.
Q-7
When the setup lock function is activated, the settings listed below cannot be changed, and “Setup Locked” is
displayed when related buttons are operated.
\‘
l System setup settings
l Surround parameter settings
l Tone control settings
l Channel level settings (including test tones)
To unlock, press the System Setup button again and display the Setup Lock screen, then select “OFF” and press
jog stick “ENTER”.
I This completes system setup. Once these settings are made, there is no need to change them unless different AV components are
connected or the speakers are repositioned.
This button can be pressed at any time during the system setup process to complete the process
At the System Setup Menu, press the SYSTEM SETUP button.
% The changed settings are entered and the on-screen display turns off.
% Finally set the remote control unit (RC-8000) display time setting to a time that is short but long enough that operation is possible. (page 19)
36
To Next Page
Loading...
Need help?
General
