q
CAUTIONS ON USE
W Place of use
Do not drop or subject to strong shocks. Dorng to could result in damage.
W Handling
The touch panel (display) IS made of glass. Do not apply pressure to It. drop the set, lean on the touch panel with
Your elbows or place heavy objects on It. Dorng so could break the touch panel and the fragments of glass could
cause injury.
n
Cleaning
Use a soft cloth to wrpe dirt off the touch panel (display), the surface of the case and the buttons. Do not use
thinner, benzene, alcohol. etc., as they could damage the surface.
q
TROUBLESHOOTING
If this unit is not operating properly, check the items listed in the table below. Should the problem persist, there may
be a malfunction.
Disconnect the power Immediately and contact Your store of purchase
Symptom
Operation IS not possible.
Cause
Measures
l
The unit is too far from the amplifier.
l
Move the unit closer to the
amplifier (within 7 meters) when
operatrng it.
l
There is an obstacle between the
l
Remove the obstacle.
unit and the amplifier.
l
The amplifier’s power IS not on.
l
Turn on the amplifier’s power.
l
The transmitter is not pointed at the
l
Point the transmitter at the
amplrfier. amplifier.
l
There is an inverter type fluorescent
l
Move the unit and the amplifier
light near the unit or the amplifier. away from the fluorescent light.
l
You are usrng products of other
l
Depending on the manufacturer and
brands. type of product, it may not be
possible to operate product wrth
this unit.
Lrquid crystal display does
l
The panel is turned off.
l
Touch the touch panel or press the
not turn on.
LIGHT button. If LCD is still not
displayed, press the RESET button.
(See page 4.)
l
The brightness is not properly set.
l
Refer to “Adjusting the brightness
of the liquid crystal display” (see
page 4) and adjust the brightness of
the lrquid cn/stal display.
Touch panel cannot be
l
Touch panel adjustment IS off.
l
Adjust the touch panel.
operated accurately. (See page 5.)
33
To Next Page
Loading...
Need help?
General
