0
12 LISTENING TO THE RADIO
To operate the tuner by remote control, switch the remote control device to “TUNER”
1
Set the input function to “TUNER”.
Then switch the remote control device to “TUNER”
(Mm unit) IRemote Cmtrol un,t,
2
Watching the display, press the BAND button to select the
desired band (AM or FM).
BAND
q
ikmote control unit)
3
Press the MODE button to set the auto tuning mode.
“AUTO” appears on the display
(Remote control unit)
4
Press the TUNING UP or DOWN button.
Automatic searching begins,
then stops when a station is
tuned in.
If tuning does not stop at the desired station, use to the “Manual
tuning” operation.
1
Set the input function to “TUNER”.
3
Press the MODE button to set the manual tuning mode.
Then switch the remote control device to “TUNER”.
Check that the display’s “AUTO” indicator turns off.
2
Switch the remote control device to “TUNER”.
4
Press the TUNING UP or DOWN button to tune in the desired
Watching the display, press the BAND button to select the
station.
desired band (AM or FM).
The frequency changes continuously when the button is held
in
l When in the auto tuning mode on the FM band, the “STEREO” indicator lights on the display when a stereo broadcast is tuned in At open
frequencies, the noise is muted and the “TUNED” and “STEREO” indicators turn off.
l When the manual tuning mode is set, FM stereo broadcasts are received in monaural and the “STEREO” indicator turns off.
66
To Next Page
Loading...
Need help?
General
