When “USER” is registered in the rcon display section and the “User Menu” is set, the user screen (“CUSTOM l/2”)
always appears when the liqurd crystal display IS redisplayed.
“Learn” buttons that are frequently used at the user menu to eliminate the trouble of searching for buttons and make
operation easrer.
@ Press the “SETUP” icon in the icon drsplay sectron for at least 3 seconds to display the setup screen.
Press the “User Menu OFF” button on the “Setup 3/4” page to set thus to “ON”. When this IS done. the user
menu is always displayed when the liquid crystal display IS redisplayed.
The setting switches between “ON” and “OFF” each time the button is pressed.
Screen 0
USER screen (1) USER screen (2)
This setting cannot be made unless “USER” is registered rn the icon display section
q
ONE-BUTTON SEARCH FUNCTION
Try using this function if you cannot find the desired remote control signals with the normal preset memories.
III Using the one-button search function
Learn the “POWER” button of the remote control
unrt for which you want to set the preset memory in
order to search for the preset memory for those
remote control srgnals.
@ At the “Edrt Devrce” and “Add Device” brand
selectron screens when setting the preset
memory rn section “Changrng the preset
memory of preset devices” on page 12, press
the “Search” button to display the learnrng start
screen.
Screen m
@ Press the “Learning Start” button on the
learning start screen, then press the “POWER”
button of the remote control unit for which you
want to set the preset memory to learn it.
To Next Page
Loading...
Need help?
General
