l Set the method of playback of the analog input signal connected to the Extln-1 and Ext.ln-2 terminal
1
f
At the System Setup Menu select “Extln Setup”.
mmmlm
System Setup Menu
M
Audio Delay
Multi Zone Control
Auto
Surround Mode
uExt. In Setup
Digital Multi Ch In
On Screen Display
Auto
Tuner
Presets
Setuo Lock
Switch to the Extln Setup screen
FEXT. I N-l
EXT. IN-2
EXIT
3
ci> Select the input terminal.
3 Switch to the setting screen.
f
luwslls
Illm
a
6
%
EXT.
IN-1 Setup
4
f
HIIRon
Select the item to be set (push the jog stick to the
lulWlU
0
up and down) then select the parameter (push the
jog stick to the left and right).
+
Hvfode
S Back :NOKSED:
SW Level 4 +lzE$ ;
Input Vol. 1
J
MODE:
DSP:
The analog input signal IS converted into a digital signal and undergoes DSP processrng.
System Setup settings (speaker configuration, channel delay, etc.) are reflected in the same way as for other Input signals.
ANALOG: The analog input signal is played without DSP processing.
SW and center channel: Down-mixing is conducted by the analog crrcuit. Surround and surround back channels: Not output
if “No” is selected at the speaker configuration. Channel delay: Not reflected.
S.Back:
Set when MODE is set to DSP. Select according to the specifications of the player being used. Also refer to the player’s operating
instructions.
NOT USE: Select when neither SBL or SBR is connected.
SB (SBL): Select when only one surround back channel (SBL) is connected.
SBL/SBR: Select when two surround back channels (SBL and SBR) are connected.
SW Level:
Select according to the speciftcations of the player being used. Also refer to the player’s operating Instructions.
+I 5dB (default) recommended. (0, +5, 10 and +15 can be selected.)
INPUT Vol.:
Set when MODE is set to DSP.
If the OVER LOAD indicator is displayed on the fluorescent tube, adjust the input level to between 0 and -20 dB
5
Meam
Enter the setting.
The System Setup Menu reappears
33
To Next Page
Loading...
Need help?
General
