[31 Dolby Headphone recording
l When RECOUT mode is set to “source”, with the AVR-5803 it is possible to output signals encoded in the Dolby Headohone mode from
the recording output terminal and record them on a separate recorder.
1
The Dolby Headphone play mode is set when headphones are
connected to the PHONES jack during playback in the
DOLBY/DTS surround mode.
2
When this is done, signals encoded in the Dolby Headphone
mode are automatically output from the recording output
terminals (analog and digital) and can be recorded.
3
Select the parameters and set the desired mode, then record.
(Refer to the f&j SURROUND “Dolby Headphone” page 60.)
NOTE:
Do not disconnect the headphones during recording.
141 Outputting a program source to an amplifier, etc., in a different room (M-ZONE 1 mode)
1
Press the M-ZONE 1 button.
M-ZONE 1
2
Select the source you want to output
appears on the set’s display.
3
Start playing the source to be output.
l For operating instructions, refer to the manuals of the
respective components.
[5] Outputting a program source to an amplifier, etc., in a different room (M-ZONE 2)
1
Press the REC/M-ZONE 2 button until
REC i
“M-ZONE 2 *c***” appears on the
M-ZONE 2
set’s display.
?
tMain unit)
2
Select the source you want to record
FUNCTION
appears on the set’s display.
l The MULTI indicator lights.
l The indicator for the selected
program source light.
KS
l When the AVR-5803 is in the REC
(Mm “rut,
OUT mode, the source cannot be
output using the M-ZONE 2 buttons
on the remote control unit.
3
Start playing the source to be output.
l For operating instructions, refer to the manuals of the
respective components.
When “M-ZONE 2” is selected for the system setup’s multi-zone
setting, the source selected here is output from the M-ZONE 2
speaker terminals.
The volume can be adjusted and the input source can be selected
using the VOLUME UP and VOLUME DOWN buttons on the remote
control unit’s “M-ZONE 2” page.
Display
l The signals of the source selected in the M-ZONE-2 mode are
1 “0, jacks. 1
also output from the TAPE and VCR recording output terminals.
l Digital signals are not output from the MULTI ZONE 1 audio
43
To Next Page
Loading...
Need help?
General
