Denon AVR-X2400H

Other Audio Case2
.
"Audio Case2"
Try Limit mode (Dolby Atmos)
Set "Dolby Atmos:Limit".
Question 1
Has your issue been fixed?
Yes No
Keep the Limit Mode
Please check
the Source Device
(Note 1)
Yes
No
Please try another audio check again.
If your issue has been fixed, go to "Yes".
If your issue has not been fixed, go to "No".
(If you get the another Diag. ID, try another flow)
End
Please check the AV
Receiver setting.
(Note 2)
Question 2
Are the AV Receiver settings correct ?
Yes No
Please call
Customer Service
Please retry
setting the AVR
and try another video check.
Try *** :AVR operation
Question * :Question for user to answer
Note 1 : Source Device check item (For details (v p. 40))
Note 2 : AV Receiver check item (For details (v
p. 40))
Introduction How to operate Cable Test Limit mode Log & EDID Troubleshooting
39