4. Protection Pass Mode
5. CY920 Reboot Mode
6. CY920 Initialization Mode
4.1. Actions
• This mode allows the power to be turned on without activating protections.
• This mode functions in the same way as normal power-on, except that protections are not activated.
4.2. Operations
2. While holding down buttons "
TUNER PRESET CH +
", "
ZONE2 SOURCE
" and "
STATUS
" simultane-
ously, press the power button to turn on the power.
The device returns to the normal display message after the following is displayed.
Protection Pass
This is displayed for 5 seconds before returning to the normal display.
5.1. Actions
• The CY920 is restarted after CY920 hang up.
• The CY920 can be restarted even in the network standby setting.
("Setup menu" – "Network" – "IP Control" – "Always On")
5.2. Operations
(1) Turn the "
MAIN ZONE
" button On and set the input source to NETWORK.
(2) While the power is on, hold down buttons "
TUNER PRESET CH +
" and "
TUNER PRESET CH -
" for
at least 3 seconds.
Display during CY920 reboot
Network Restart
(4) Returns to the normal display.
NOTE :
• After rebooting CY920, the same operation is not accepted for 1 minute.
• Reception is prohibited during update, save and load.
6.1. Actions
The following items are initialized.
(1) Favorites
(2) Quick Select
(3) Presets
(4) Internet Radio Recently Played
(5) Flickr contacts
(6) User ID
(7) Resume Playback station
6.2. Operations
While the power is on, hold down buttons "
ZONE2 SOURCE
" and "
DIMMER
" for at least 3 seconds.
Initializing Display
Initializing
Initializing.
Initializing..
Initializing...
Complete Display
Completed
This is displayed for 5 seconds before returning to the normal display.
Failed Display
Failed
125
Caution in
servicing
Electrical Mechanical Repair Information Updating
To Next Page
Loading...
Need help?
General
Weight and Dimensions
