5. Protection Pass Mode
5.1. Actions
• This mode allows the power to be turned on without activating protections.
• This is the same as normal power-on, except that protections are not activated.
5.2. Operations
Hold down buttons "
CURSOR
0
", "STATUS" and "ZONE3 SOURCE" at the same time and press the power button to turn
on the power.
The device returns to the normal display after the following is displayed.
FLD L1
P r o t e c t i o n P a s s
This is displayed for 5 seconds before returning to the normal display.
6. CX870 / CY920 Reboot Mode
6.1. Actions
• The CX870 / CY920 is restarted after CX870 / CY920 hangup.
• The CX870 / CY920 can be restarted even in the network standby setting.
("
Setup menu
" – "
Network
" – "
IP Control
" – "
Always On
")
6.2. Operations
(1) Select "
Online Music" as the input source.
(2) Hold down buttons "
DIMMER" and "SETUP" for at least 3 seconds while the power is on.
FL display during CX870 / CY920 reboot
FLD L1
N e t w o r k R e s t a r t
(3) Returns to the normal display.
NOTE:
• The CX870 / CY920 Reboot operation is not accepted again for one minute after executing the reboot.
• Reception is prohibited during update, save and load.
75
To Next Page
Loading...
Need help?
General
Weight and Dimensions
