Denon AVR-X5200W Service Manual

Error
Code
DPMS Update Error Display Details of Error code Coping strategies
12
M a i n * * * m i n
U p d a t i n g f a i l 1 2
Abnormal data in Update Packet
received from CX870 (PacketNo-
Error).
Turn on the power again. Update will
start automatically.
13
M a i n * * * m i n
E r a s e f a i l 1 3
Block Erase failed before rewriting
Main.
Turn on the power again. Update will
start automatically.
14
M a i n * * * m i n
U p d a t i n g f a i l 1 4
Block Write failed while rewriting
Main.
Turn on the power again. Update will
start automatically.
15
M a i n * * * m i n
U p d a t e C h e c k N G 1 5
Error in Verify after rewriting Main
(Check SumError).
Turn on the power again. Update will
start automatically.
16
M a i n * * * m i n
U p d a t i n g f a i l 1 6
Setup failure of the transfer
method of XModem.
Check the network connection. Update
in an environment where there is a
small network load.
20
C o n n e c t i o n f a i l
2 0
SBL Mode after IP Address acqui-
sition failure (AutoIP).
Check the network connection. Update
in an environment where there is a
small network load.
21
C o n n e c t i o n f a i l
2 1
SBL Mode after IP Address acqui-
sition failure (Time Out).
Check the network connection. Update
in an environment where there is a
small network load.
22
L o g i n f a i l e d
2 2
Login incorrect notication SBL
Mode after DPMS connection.
Initialize the unit and try updating
again.
Update in an environment where there
is a small network load.
23
S e r v e r i s b u s y
2 3
Server congestion notication SBL
Mode after DPMS connection.
Update in an environment where there
is a small network load.
24
C o n n e c t i o n f a i l
2 4
Connection failure notication
SBL Mode after DPMS connection.
Check the network connection. Update
in an environment where there is a
small network load.
25
C o n n e c t i o n f a i l
2 5
Failed to transit to SBL Mode.
Initialize the unit and try updating
again.
26
D o w n l o a d f a i l
2 6
Error in Firmware Download (Time
Out).
Check the network connection. Update
in an environment where there is a
small network load.
27
C o n n e c t i o n f a i l
2 7
Failed to write to EEPROM after
SBL Mode.
Initialize the unit and try updating
again.
36
M a i n * * * m i n
L o g i n f a i l e d 3 6
Login incorrect notication DPMS
connection.
Update in an environment where there
is a small network load.
37
M a i n * * * m i n
S e r v e r i s b u s y 3 7
Server congestion notication by
DPMS connection.
Update in an environment where there
is a small network load.
38
M a i n * * * m i n
C o n n e c t i o n F a i l 3 8
Connection failure notication
DPMS connection.
Check the network connection. Update
in an environment where there is a
small network load.
90

Denon AVR-X5200W Specifications

General

Receiver type	Surround
Frequency range	20 - 20000 Hz
Output impedance	16 Ω
Speaker selector	A+B
Pre-out connectivity	Yes
Audio output channels	- channels
Power output per channel (1KHz@6 Ohm)	205 W
Power output per channel (20-20KHz@8 Ohm)	140 W
HDMI in	8
Remote (IR) input	1
Composite video in	5
Component video (YPbPr/YCbCr) in	2
Number of HDMI outputs	3
Connectivity technology	Wired & Wireless
Speakers connectivity type	-
Audio formats supported	AAC, AIFF, FLAC, MP3, WAV, WMA
Image formats supported	JPG
Supported radio bands	AM, FM
Internet radio services supported	Spotify, vTuner
Optical drive included	No
Product color	Silver
Audio decoders	Dolby TrueHD, DTS 96/24, DTS Neo:X, DTS-ES, DTS-HD Master Audio
AC input voltage	230 V
AC input frequency	50 Hz
Power consumption (standby)	0.1 W
Power consumption (typical)	730 W

Weight and Dimensions

Depth	393 mm
Width	434 mm
Height	167 mm
Weight	14200 g