Denon AVR-X6200W - Protection Pass Mode; CY920 Reboot Mode

4. Protection Pass Mode
4.1. Actions
• This mode allows the power to be turned on without activating protections.
• This mode functions in the same way as normal power-on, except that protections are not activated.
4.2. Operations
2. While holding down buttons "
CURSOR
0
", "
STATUS
" and "
ZONE3 SOURCE
" simultaneously, press the power
button to turn on the power.
The device returns to the normal display message after the following is displayed.
FLD L1
P r o t e c t i o n P a s s
This is displayed for 5 seconds before returning to the normal display.
5. CY920 Reboot Mode
5.1. Actions
• The CY920 is restarted after CY920 hang up.
• The CY920 can be restarted even in the network standby setting.
("Setup menu" – "Network" – "IP Control" – "Always On")
5.2. Operations
(1) Turn the "
MAIN ZONE
" button on and set the input source to NETWORK.
(2) While the power is on, hold down buttons "
DIMMER
" and "
SETUP
" for at least 3 seconds.
Display during CY920 reboot
FLD L1
N e t w o r k R e s t a r t
(4) Returns to the normal display.
NOTE :
• After rebooting CY920, the same operation is not accepted for 1 minute.
• Reception is prohibited during update, save and load.
75