EasyManuals Logo

Denon AVR-X6200W Service Manual

Denon AVR-X6200W
218 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #89 background imageLoading...
Page #89 background image
2. Updating via DPMS
Download the latest rmware from our website and update the rmware.
2.1. Network Connection
(1) System Requirements
Internet Connection by Broadband Circuit
Modem
Router
Ethernet cable (CAT-5 or greater is recommended)
(2) Setting
2.2. Check and update the rmware
Check if there is a rmware update available. It is also possible to check approximately how long the update will take.
(1) Press the "
SETUP
" button on the remote control to display the GUI menu.
(2) Press the cursor button to select "General" → "Firmware" → "Update" → "Check for Update".
(3) Press the "
ENTER
" button.
The latest version of the rmware uploaded to the web is displayed.
If the latest rmware version is on the web, proceed to (4).
• If the latest rmware is already installed, press the "
SETUP
" button to exit the menu.
(4) Select "Start" using the cursor buttons, and then press "
ENTER
".
The power display lights in red and the GUI screen display disappears during the update.
The remaining time of the update is shown on the display of the unit.
Returns to the normal status after update is completed.
---Cautions on Firmware Update---
For the update procedure, a proper broadband Internet connection environment and settings are required.
Do not turn off the power until updating is completed.
It takes around 1 hour to complete the update.
Once an update is started, normal operations cannot be performed until it is completed.
The GUI menu settings and image adjustment settings of this unit may be initialized.
Note down the settings before updating, and set them again after updating.
Modem
Internet
Computer
ComputerLAN port / Ethernet connector
Ethernet connector of this Unit
Router
To WAN port
To LAN port
To LAN port
89

Table of Contents

Other manuals for Denon AVR-X6200W

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-X6200W and is the answer not in the manual?

Denon AVR-X6200W Specifications

General IconGeneral
DisplayVFL
Product colorSilver
RS-232 ports1
12V trigger ports quantity2
Speakers connectivity typeRCA
HDMI in8
Composite video in5
Receiver typeSurround
Frequency range10 - 100000 Hz
Pre-out channels13.2
Input sensitivity200 mV
Audio output channels9.2 channels
Signal-to-Noise Ratio (SNR)102 dB
Power output per channel (1KHz@6 Ohm)205 W
Power output per channel (20-20KHz@8 Ohm)140 W
Number of HDMI outputs3
AC input voltage230 V
AC input frequency50 - 60 Hz
Power consumption (standby)0.1 W
Power consumption (typical)730 W
AM band range522 - 1611 kHz
FM band range87.5 - 108 MHz
Supported radio bandsAM, FM
Internet radio services supportedSpotify
3D-
Supported graphics resolutions4096 x 2160
Card reader integratedNo
Audio formats supportedAAC, AIFF, ALAC, FLAC, MP3, WAV
Image formats supportedJPG
Weight and Dimensions IconWeight and Dimensions
Depth383 mm
Width434 mm
Height167 mm
Weight14100 g

Related product manuals