Denon DCD-3560 - Playback Modes and Operations; Disc Handling and Loading; Normal CD Playback; Advanced Playback Features

NORMALCDPLAYBACK __
OPENING AND CLOSING THE DISC HOLDER AND
LOADING A DISC _
Opening and closing the disc holder (This operation only works while the
power is on.)
1. Press the power switch (POWER) to turn on the power.
2. Press the open/close button ( ;!; OPEN/CLOSE).
(1)
s .. :_~ PI.yb". ( • PlA~~
II • II ~1i:-::::'B8 ;;;"'88:"88,:!"=IIIC!lQ
II II v ......... - ......... _. 11~c:::J
c:::::::.:::::: =:'0
Data cannot be read properly
Normal
~~
~~).~~~ ~ .
~;c,&
?,',':,:,. __ ._ 0 0 0 0 lilililililililili Oil 0 (Il)~'
--- - - -- _._._- ---- -- (. STOP)
• If the data at the innermost section of the disc cannot be read properly
due to scratches, dirt, etc., the display window will be as shown below.
If this happens, the search operation may take more time than usual.
lR",,< ''<0£' lI"'E
" ,-, .-." li,j " n
'-"_' '-' '.' LI Ul'1Lr '-'5
NOTE:
•
If no disc is loaded or if the disc is loaded'upside*down, "00" appears
on the TRACK display, then the entire display window changes to
"00000000"
1 Press the power switch (POWER) to turn on the power.
2 Load the disc you want to play.
•
When the disc holder is closed, the disc is read and the number of
tracks and total playing time of the disc are displayed.
3 Press the play button ( ~ PLAY).
Press
the stop button ( • STOP).
•
When all tracks have been played on a disc, playback will stop by itself.
(2) Stopping Playback
Fig. 1
Tray guide for 12 cm disc
r---------------.---- ---',
How to load a disc
• Make sure the disc holder is completely open.
• Hold the disc by the edges and place it on the disc tray. (Do not touch
the signal surface, i.e., the glossy side.)
•
When using 12 cm. diameter discs, make sure the outer edge matches
the tray guide circumference (Fig. 1). and when using CD singles (8 cm.
diameter) match the outer edge with the inner tray guide circumfer-
ence. (Fig. 2)
• Press the open/close button ( ;!; OPEN/CLOSE) to close the disc holder.
•
When the disc is loaded, the total number of tracks is indicated in the
TRACK
display, the total time is indicated in the TIME display, and the
numbers in the calendar light up to the total number of tracks.
•
When the disc holder is open and a disc is loaded, you may also press
the play ( ~ PLAY) or pause ( II PAUSE) button to close the disc holder.
(If
the play button ( ~ PLAY) is pressed, playback will start immediately
upon the disc contents having been read.)
Fig. 2
,&
ff
Tray guide for 8 cm disc
(CD single)
Caution:
• If your finger should get caught in the disc holder when it closes, press
the
open/close button ( ;!; OPEN/CLOSE).
• Do
not place any foreign objects on the disc tray, and do not place more
than one disc on the tray at a time. Otherwise malfunction may occur.
• Do
not push in the disc tray manually when the power is off as this may
cause a malfunction and damage the CD player.
ADVANCED CD PLAYBACK _
o Playing a Specific Track Direct Search INumber buttons I
• Use the number buttons and the +10 button to input the number of the
desired track.
For example, to play. track number 4, press [ill, and to play track number
12, press [±IQ] and [2J. Playback will begin from that track.
8 Advancing to the next track
during playback I Automatic Search I
(~)
Press the Automatic search forward button ( ~I ) during playback.
•
The pickup will advance to the beginning of the next track and playback
will continue. Pressing the button several times will forward the pickup
to the corresponding number tracks.
7