5
DCD-CX3
2. フロントパネルのはずしかた
(1) フロントパネル上部の切り欠き部 (2ヶ所)からネジが
見える位置まで、トレイを押し込みます。(fig.A参照)
(2) ネジ 2 本をはずします。(fig.B参照)
(3) フロントパネルを取り付けている、上部のネジ 3 本と
底部のネジ 3 本をはずします。
(4) フロントパネルを矢印の方向にはずします。
※ フロントパネルを廃棄する場合は、下図のように分解し
てください。
2. Front Panel Ass’y
(1) Press the tray in to the position at which screws can be
seen through the 2 cuts in the top of the Front Panel.
(Refer to Fig. A)
(2) Remove 2 screws. (Refer to Fig. B)
(3) Remove 3 top screws and bottom 3 screws, then de-
tach the Front Panel Ass’y.
※ If front panel is abandoned, disassemble according to
below.
fig. A
fig. B
MECHA HOLDER
MECHA BRACKET