Denso BHT-604Q - System Configuration

2
BHT-604Q
1.1 System Configuration
This section describes the hardware required for the barcode data collection system used by the BHT and the BHT
software.
1.1.1 System Configuration
In addition to the BHT, the following hardware and software are required for the barcode data collection
system used by the BHT.
Please note that certain components of the required hardware will differ depending on the type of
communication used.
 Host computer
 CU-600 Series (option): Communication unit
 Connection cable (option): Used to connect the BHT and host computer.
 Software: BHT-BASIC 4.0 Development Pack (Option) and BHT-BASIC 4.0 Transfer Utility (Option)
Host com
p
ute
r
BHT
CU
(
o
p
tion
)
(1) Connector
communication
(2) IrDA
communication
BHT-BASIC 4.0
Transfer Utility (Option)
BHT-BASIC 4.0
Develo
p
ment Pack
(
O
p
tion
)
● : Required f
or system configuration
Host computer BHT CU
Wireless LAN
access point
Software Ref. Page
(1)Connector
communication
● ● — — ●
Page 32
(2) IrDA
communication
● ● ● — ●
Page 33