Denso BHT-604Q - Software Configuration

4
BHT-604Q
1.1.2 Software Configuration
This section describes the software used for BHT Series application development and application in
addition to the software used at the BHT unit.
Please note that the above-mentioned software can be downloaded (Certain versions may be for trial
use.) from the QBdirect service discussed at “Customer Registration” on page ii.
[1] Application Development Procedure
The procedure for BHT Series program development is as follows.
Program creation
Program generation (compiling and linking)
Program download
Program ex
ecution and debugging
[2] Software Used for Application
 BHT-BASIC Programmer’s Manual for BHT-600 Series
This is an instruction manual used to create handy terminal programs with BHT-BASIC.
 BHT-BASIC4.0 Development Pack (option)
This is a package containing four software products required for BHT Series application development and
accessories.
The BHT-BASIC 4.0 Development Pack contains the following products.
 BHT-BASIC 4.0 Compiler
Compiles and links a source program written in BHT-BASIC 4.0 to create a user program executable on
the BHT (*.PD4).
 BHT-BASIC 4.0 Simulator
Performs an operation check for generated application programs (*.PD4) at the computer.
 BHT-BASIC 4.0 Remote Debugger
Uses the BHT unit to debug generated application programs (*.PD4) at the computer.
 BHT-BASIC4.0 Transfer Utility
Transfers files between the host computer and BHT at the host computer.
YMODEM or BHT-Ir protocol is used for file transfer.
BHT-BASIC 4.0 specification files such as application programs and data files are transferred using
YMODEM protocol.