24
BHT-604Q
About “$$BRKLST.SYS”
If Scandisk finds an invalid file(s), it will automatically create the “$$BRKLST.SYS” file.
To check the contents of the file, upload the file in System Mode to the host computer.
(Refer to “Chapter 4 System Operation” – “4.5.3 Uploading Files (UPLOAD MENU).”)
Contents of the “$$BRKLST.SYS” file
(1) File name
(2) Error factor + (Broken since the BHT has not been turned off normally)
* (Broken due to any other causes)
Records
(3) Broken records e.g. 01000-01200 (Data in records numbered 1000 to 1200
is lost)
[Ex.]
SAMPLE1.DAT + 01000-01050 If more than one sequence of records is broken in a same file,
SAMPLE1.DAT + 01200-01250 they will be written into the subsequent records in the
SAMPLE1.DAT + 01600-01650 “$$BRKLST.SYS.”
SAMPLE2.DAT * 00250-00275
SAMPLE3.DAT * 00100-00150
↑
↑ ↑
① ② ③
2.5.5 If Invalid Files Are Found
Even invalid files can be uploaded, so upload them to the host computer according to your needs.
Delete those invalid files.
(Refer to “Chapter 4 System Operation” – “4.5.9 Deleting Program/Data Files (DELETE FILE MENU).”)
Download valid files having the same names as invalid ones.
(Refer to “Chapter 4 System Operation” – “4.5.2 Downloading Files (DOWNLOAD MENU).”)
To Next Page
Loading...
