21
2D Code Handy Terminal
2.5 Turning OFF the Power
You can turn OFF the BHT in one of the following three methods.
Normal Power OFF → Press the Power key (
).
Turning the power OFF after data back-up → Hold down the Power key (
) for at least 3 seconds.
Auto power OFF → The power turns OFF itself when the BHT is not used for
specified period of time set at the user program.
2.5.1 Normal Power OFF
1. Press the Power key ( ).
The BHT turns OFF after the message on the screen given to the right
displays.
Point Do not remove the battery
cartridge while the message
on the right is displayed.
When the power is next
turned ON, there are times
when a message (2XXX )
displays asking the user to
contact the administrator.
2.5.2 Turning the Power OFF after Data Back-up
1. Hold down the Power key ( ) for at least 3 seconds.
The message right displays and data back-up is commenced.
The power turns OFF itself when the back-up is complete.
Point Do not remove the battery
cartridge while the message
on the right is displayed.
The back-up process may
take several tens o
seconds depending on the
amount of data.
2.5.3 Auto Power OFF
The power turns OFF itself when the BHT is not used for the specified period of time set at the user
program.
This is set to 3 minutes at default when the BHT is shipped from the factory.
* Refer to “BHT-600 Programmer’s Manual” for details of auto power OFF.
To Next Page
Loading...
