63
2D Code Handy Terminal
[1] Setting the auto-start execution program
Use the following procedure to set the auto-start execution program.
1. Select “1: EXECUTE PROGRAM” at the SET SYSTEM menu and then
press the ENT key.
The SET EXECUTE PROGRAM menu screen screen displays as shown on
the right.
The highlighted program will be the program currently set as the auto-start
execution program.
2. Use the cursor keys ([▲] [▼]) to highlight the target program.
3. Press the ENT key.
The selected program will be set as the auto-start execution program.
Press the C key to return to the SET SYSTEM menu.
The screen screen displays as shown on the right if no programs have been
downloaded.
Press the C key to return to the SET SYSTEM menu.
To Next Page
Loading...
