Barcode Handy Terminal
If Scandisk finds a broken file(s), the right screen will appear.
(As long as a broken file exits, the screen displays every
time the BHT
candisk when the resume function is enabled
Scandisk runs when the resume function is enabled, the screen given right
ay appear.
he BHT displays the screen for three seconds and then automatically runs
the execution program from the beginning.
− Point − The resume function is used to return the display to the status (screen) where the power was last
turned OFF when the power is next turned ON.
Resume function settings are made at the “SET SYSTEM” menu. Refer to “Chapter 4 System
Operation” - “4.5.5 System Environment Settings (SET SYSTEM Menu)” for further details.
System is started up.)
(Refer to “About “$$BRKLST.SYS” on the following page.)
S
If
m
T
(The screen may also appear when the calendar clock built in the BHT stops,
even without running Scandisk.)
23
To Next Page
Loading...
