BHT-805B
3.5.1 IrDA Communication
When performing data communication between BHT units
Point the BHT IrDA communication ports toward each other and perform communication.
Requests
• Make sure that the light path between the BHT and any target stations is not obstructed.
• Perform communication within the effective infrared emission range (15 cm).
• Do not operate remote control units for televisions and so forth in the vicinity of IrDA communication.
This may result in comunication failure.
• Perform communication in locations where the BHT units will not be exposed to light interference from
sources such as intense ambient lighting (inverter-driven fluorescent lighting, in particular) or direct
sunlight. This may result in comunication failure.
When performing data communication with the host computer
Place the BHT on the communication unit (CU-801, CU-811 or CU-821) and transmit data.
In case of using the CU-601 or CU-621, the BHT-BASIC 4.0 Development Pack (Option) and BHT-BASIC
4.0 Transfer Utility (Option) software is required.
In case of using the CU-611, FTP communication environment is required.
CU-801: RS232C
CU-811: Ethernet
CU-821: USB
32
To Next Page
Loading...
