Barcode Handy Terminal
[1] Setting the auto-start execution program
Use the following procedure to set the auto-start execution program.
1. Select “1: EXECUTE PROGRAM” at the SET SYSTEM menu and
then press the ENT key.
The SET EXECUTE PROGRAM menu screen on the right displays.
The highlighted program will be the program currently set as the auto-start
execution program.
2. Use the cursor keys ([▲] [▼]) to highlight the target program.
3. Press the ENT key.
The selected program will be set as the auto-start execution program.
Press the BS/C key to return to the SET SYSTEM menu.
The screen displays as shown on the right if no programs have been
downloaded.
Press the BS/C key to return to the SET SYSTEM menu.
65
To Next Page
Loading...
