Denso GT10B-SU - Page 58

49
Standard 2of5
Items Parameters Defaults Refer to:
Enable, without C/D
Enable, with C/D
Scanning Standard 2of5
Disable √
Minimum number of digits readable
for Standard 2of5
3 digits
Maximum number of digits readable
for Standard 2of5
1 to 99 digits
99 digits
(See Note 3.)
Enable √
Transmission of a check digit
for Standard 2of5
Disable
Section 11.3 (5)
(See Note 4.)
Enable
Specification of the number of digits for
Standard 2of5, by bar code scanning
Disable √
Section 8.2
Interleaved 2of5
Items Parameters Defaults Refer to:
Enable, without C/D √
Enable, with C/D
Scanning Interleaved 2of5
Disable
Minimum number of digits readable
for Interleaved 2of5
4 digits
Maximum number of digits readable
for Interleaved 2of5
2 to 99 digits
99 digits
(See Note 3.)
Enable √
Transmission of a check digit
for Interleaved 2of5
Disable
Section 11.3 (5)
(See Note 4.)
Enable
Specification of the number of digits for
Interleaved 2of5, by bar code scanning
Disable √
Section 8.2
Codabar (NW-7)
Items Parameters Defaults Refer to:
Enable, without C/D √
Enable, with C/D
Scanning Codabar (NW-7)
Disable
Minimum number of digits readable
for Codabar (NW-7)
4 digits
Maximum number of digits readable
for Codabar (NW-7)
3 to 99 digits
(including start/stop codes)
99 digits
(See Note 3.)
Enable √
Transmission of a check digit
for Codabar (NW-7)
Disable
Section 11.3 (5)
(See Note 4.)
(Note 3) The setting range does not mean the number of digits that the scanner can read.
(Note 4) To enable the transmission of a check digit, it is also necessary to select the "Enable, with C/D" parameter.
: Can be changed only with the configuration software.