Technical Specification DESKO PENTA Scanner
®
&
Page 9 of 37
DESKO PENTA Scanner
®
BGR & DESKO PENTA Scanner
®
CKI
3.2.2 RFID & NFC Reading
The integrated RFID Module is designed for ID1 document reading. The RFID Module can
read RFID documents according to ISO 14443 (A/B), ISO 7816 and ICAO 9303.
Selection of supported RFID/NFC tags of the ISO/IEC 1443 (A/B) standard:
• ePassport
• Mifare
• Mifare classic
• Mifare ultralight
Other standards like ISO/IEC 15693 upon request.
Note: RFID ePassport reading for BAC takes approx. 1.5 seconds, depending on the PC system
and application. Generally, the type of ePassport/e-ID can also influence RFID reading
performance. This is due to different chip sets and chip OS in various ePassport/e-ID
document types. RFID ePassport reading speed may therefore vary from document to
document.
3.2.3 RFID Reading for eID or Mobile ID Reading
The integrated RFID Module supports a second antenna which is installed in the scan area.
This antenna can be used to establish a RFID communication with e.g. a smart phone for eID
or Mobile ID reading according to ISO/IEC 7816.
Please refer to paragraph 6 for further details on how to perform eID or Mobile ID reading.
3.2.4 MSR Reading (Key Feature of DESKO PENTA Scanner
®
BGR &
DESKO PENTA Scanner
®
CKI)
The integrated up to 3-track bidirectional magnetic stripe reader is able to read all magnetic
stripe data encoded in equivalence to ISO 7811/2-5.
3.2.5 Integrated Chip Card Reader (Not Available for DESKO PENTA Scanner
®
BGR & DESKO PENTA Scanner
®
CKI)
The DESKO PENTA Scanner
®
Chip Card Reader is compliant to ISO 7816 and EMV² 2000 level
1 and designed for reading synchronous and asynchronous chip cards with the following
standards:
Standards Protocols
EMV² 2000 Level 1
2-wire: SLE 4432/42 (S=10),
3-wire: SLE 4418/28 (S=9),
I²C (S=8)
To Next Page
Loading...
