DESKO PENTA Scanner - Support; Technical Overview; Technical Data

Technical Specification DESKO PENTA Scanner
®
& Page 24 of 37
DESKO PENTA Scanner
®
BGR & DESKO PENTA Scanner
®
CKI
10 Support
Please check if the cable is connected, the software is installed properly and if the device is
powered on. If this is the case and the device still does not work, please contact our support
team by typing support.desko.com
into your web browser:
Why our website is the best way to enter support inquiries?
• The form request all necessary information (company name, contact person, device
with serial number etc.) to precess the support case immediately.
• It is possible to upload pictures or other documents to explain the problem more
detailed.
• Possible queries for the initial processing are omitted. This means the customer´s
problem can be solved more quickly.
The direct way to our online form is therefore also the best way for our customers to have
their request processed quickly.
11 Technical Overview
11.1 Technical Data
Supply Voltage:
5 V DC +/- 5 %
Limited power Source acc. to ISO/IEC 60950-1 or
PS2 (Limited power Source) acc. to ISO/IEC
62368-1
Supply Current:
max. 2,5 A
Requirement for the
external Power supply unit:
- Limited power Source according to ISO/IEC
60950-1 or PS2 classified ISO/IEC 62368-1
- Short circuit current < 8A
Operating Temperature:
0 °C - 50 °C
Storage Temperature:
-10 °C - +60 °C
Humidity:
20 % - 95 % (R.H. non-condensing)
Special conditions:
No direct sunlight on scan window
Reliability:
MTBF = 180.000 hours
(24/7 operation mode)
Certifications and Declarations
of Conformity:
Country specific reports available
CE, FCC*, CB Report, WEEE, RoHS, UKCA
*This device complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation
est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.