• Please read and observe the information
given in this Operation Manual. This will
enable you
to
avoid accidents, preserve
the manufacturer's warranty and maintain
the engine
in
peak operating condition.
• This engine has been built exclusively for
the application specified
in
the scope
of
supply, as described by the equipment
manufacturer and is to
be
used only for the
intended purpose. Any use exceeding that
scope is considered to
be
contrary to the
intended purpose. The manufacturer will
not assume responsibility for any damage
resulting therefrom. The risks involved are
to
be
borne solely
by
the user.
• Use in accordance with the intended pur-
pose also implies compliance with the con-
ditions laid down by the manufacturer for
operation, maintenance and servicing. The
engine should only
be
operated by person-
nel trained
in
its use and the hazards
involved.
• The relevantaccident prevention gUidelines
and other generally accepted safety and
industrial hygiene regulations must
be
ob-
served.
• When the engine is running, there is a risk
of
injury through:
- turning/hot components
- engines with positive ignition
- ignition systems (high electrical voltage)
You
must avoid contact at all times!
• Unauthorized engine modifications will in-
validate any
Iia
bilityclai
ms
againstthe manu-
facturer for resultant damage.
Manipulationsofthe injection and regulating
system mayalso influencethe performance
ofthe engine, and its emissions. Adherence
to legislation on pollutioncannot
be
guaran-
teed under such conditions.
•
Do
notchange, convert oradjustthe cooling
air intake area to the blower.
The manufacturershall not
be
held respon-
sible for any damage which results from
such work.
• When carrying out maintenance/repair op-
erations on the engine, the use
of
DEUTZ
original parts is prescribed. These are
specially designed for your engine and
guarantee perfect operation.
Non-compliance results
in
the expiry
of
the
warranty!
• Maintenance and cleaning
of
the engine
should only
be
carried out when the engine
is switched
off
and has cooled down.
You must ensure thatthe electrical systems
have been switched off and the ignition
key has been removed.
Accident prevention guidelines concerning
electrical systems (e.g. VDE-01 00/-01
01/
-0104/-0105 Electrical protective measures
against dangerous touch voltage) are
to
be
observed.
When cleaning with fluids, all electrical
componentsareto
be
covered impermea
bly.
To Next Page
Loading...
