Engine
Operation
II
3.2.1
Electric Starting
&
Before starting, make sure that
nobody is standing
in
the im-
,.
mediate vicinity
of
the engine
• or driven machine.
After repair work:
Check that all guards have
been replaced and that all tools have been
removed from the engine.
When starting with glow plugs, do not use any
other starter substance (e.g. injection with
start pilot). Risk
of
accident!
Caution:
If
the speed regulator has been
removed, the engine must not
be
started
under any circumstances.
Disconnect the batteryl
Do
not actuate the starter for more than
20
seconds. Ifthe engine does notcatch, waitforone
C") minute then try again.
o If the engine does not catch after two attempts,
~
refer
to
the Fault
Table
(see
7.1).
@
• Disengage the clutch to separate the en-
gine from any driven parts.
• Bring speed adjustment lever1into at least
the middle speed position
in
the direction
of
the arrow.
• Move cut-out handle 2 into operating posi-
tion counter to the direction
of
the arrow.
3.2
Starting
without
cold
start assistance
• Insert key
- Position 0
= no operating voltage.
• Turn key clockwise
- Position 1
=operating voltage
- Pilot lights 1 and 2 illuminate.
• Push key
in
and turn further clockwise
against spring pressure.
- Position 2
= no function
- Position 3
=start
• Release key as soon as engine fires
- The pilot lights will go out.
To Next Page
Loading...
