Deutz 2012 - 5.1 Maintenance Schedule

Routine Maintenance 5.1 Maintenance Schedule
Intercooler (drain lube oil/condensation)
Oil filter cartridge (at each lube oil change)
V-belts (retension or replace if necessary)
Section
3.3#
6.4.3/6.4.4
6.6.1#
6.5.1
6.7.1
#
4.2/5.2
6.1.2/3.3.4
6.1.1/ 6.1.2
4.3.1/2/3
6.1.3
6.2.1
#
Industrial engines
The specified engine maintenance values are
permissible recommended maximums.
Depending on usage, reduced maintenance
intervals may be necessary, comply with the
unit manufacturer's operating instructions.
# Maintenance must only be carried out by
authorised service personnel
Valve clearance
Engine monitoring system, warning system
Intake air cleaner (If available, maintain according to maintenance indicator)
Coolant (additive concentration)
Lube
oil (oil change intervals depending on engine use), see TR 0199-99-3002
Injection valve
Battery and cable connectors
Fuel pre-c1eaner/ filter element (cleaning or replace if necessary)
Flexible fuel leak
oil lines (replace completely)
Fuel filter cartridge
Operation
Top lube oil up if necessary
r,««<]<'« ««I Coolantpump
Coolantlevel
check= • adjust=
0 c1ean= • replace= •
Years
~ prior to or during 1st trial run, check 2x daily during the breaking in phase or
when commissioning new and overhauled engines
every 10 hours
of operation or daily
Operating hours (OP) every
* When the warning system responds (lamp/horn), the fuel pre-filter must be emptied immediately
C")
o
o
N
@