Deviser TC500 - Update

TC500 Ethernet Cabling Certifier Operation Manual
34
11. Update
Users can update OS kernel, main unit firmware, main unit software and remote unit firmware just using a U-disk.
If you update main unit OS kernel, main unit firmware, main unit software, you just copy the update file to a U-disk. Before turn on
the main unit, connect the U-disk to main unit and press On/Off key. The main unit will automatically find the update file and then
run the update process.
A message box will appear to show you the update process is running. When this process finished, the message box disappeared
and main unit will automatically shut down.
If you update remote unit firmware, first you should copy the update file to a U-disk. Turn on the main unit and remote unit;
connect the remote unit to the main unit using one equipment cord. Connect the U-disk to the main unit and turn on main unit,
and go to the Serial Number menu in Info. Then the update process runs, a message box will appear on main unit. When the
process finished, the remote automatically shut down.
WARNING:
Do not take the battery out of main unit and remote unit when update process is under run.
Do not disconnect the U-disk from main unit when update process is under run.
To update successfully, users should be sure the units have enough power and flash free space.