EasyManuals Logo

DeWalt D24000 Original Instructions

DeWalt D24000
Go to English
100 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #36 background imageLoading...
Page #36 background image
34
ENGLISH
Draining the Water Basin (Fig. V)
1. The water basin must be drained after eachuse.
2. Place the water pump on the tray
69
.
3. Place a suitable container under the drain plug
29
.
4. Remove the drainplug.
5. Allow ample time for the liquid todrain.
6. After the liquid has been drained, re-install the drainplug.
7. Dispose of the liquid with due care for theenvironment.
Adjusting the Table Rolling Resistance (Fig.W)
To take out the clearance between the table and the rails, proceed as follows:
1. Loosen the rail height screws
70
.
2. Adjust the rail height adjusters
71
until the table movessmoothly.
3. Tighten the rail heightscrews.
Lubrication
Your power tool requires no additionallubrication.
Cleaning
WARNING: Blow dirt and dust out of the main housing with dry air as often as dirt is seen
collecting in and around the air vents. Wear approved eye protection and approved dust
mask when performing thisprocedure.
WARNING: Never use solvents or other harsh chemicals for cleaning the non-metallic
parts of the tool. These chemicals may weaken the materials used in these parts. Use a
cloth dampened only with water and mild soap. Never let any liquid get inside the tool;
never immerse any part of the tool into aliquid.
Before use, carefully check the cutting disk guard to determine that it will operate properly.
Ensure that mud, or work-piece particle cannot lead to blockage of one of thefunctions.
In case of workpiece fragments jammed between cutting disk and guard disconnect the
machine from the power supply and follow the instructions given in section Mounting the
cutting disk. Remove the jammed parts and reassembling the cuttingdisk.
Keep the ventilation slots clear and regularly clean the housing with a softcloth.
The following cleaning operations must be performed everyday.
1. Insert the water pump into a bucket of clean water and pump the water through the
hosesystem.
2. Wipe the rails and support arm with a grout sponge or arag.
3. Spray the water basin and the sliding table with clear water. Wipe any dust residue away
with a groutsponge.
Storage
Store the equipment and accessories out of children's reach in a dark and dry place at above
freezing temperature. The ideal storage temperature is between 5 °C and 30 °C.
Protecting the Environment
Separate collection. Products and batteries marked with this symbol must not be
disposed of with normal householdwaste.
Products and batteries contain materials that can be recovered or recycled reducing
the demand for raw materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at www.2helpU.com.

Other manuals for DeWalt D24000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DeWalt D24000 and is the answer not in the manual?

DeWalt D24000 Specifications

General IconGeneral
Input power1600 W
Power sourceAC
Blade bore25.4 mm
Blade diameter250 mm
Idle speed (max)4200 RPM
Sound pressure level103 dB
Weight and Dimensions IconWeight and Dimensions
Depth860 mm
Width690 mm
Weight32000 g

Related product manuals