Dewetron EPAD2 Series - Push Button; Connection; Programming Information

49
EPAD2/CPAD2/CPAD3 series modules • Technical Reference Manual • Printing version 1.0.2 • October 04, 2016
Push button
Use the ID button to dene the module address via software. Detailed information how to use the button is
available in chapter: "Installing EPAD2/CPAD2 modules in DEWESoft, Module reset".
Connection
1 Current input connectors
2 State LED
3 ID button
4 2x xPAD2 interface connector
12 3
4
LA input connector
The xPAD2-LA module offers 8 isolated current input channels.
1
2
4
3
Pin assignment:
1 Power supply (+)
2 Current (+)
3 Current (-)
4 Power supply (-)
Shield is on housing
Schematic
EGB.1B.304
xPAD2 interface connector
This connector can be used to connect the module to the EPAD-BASE2 module or other xPAD2 series
1
2
4
3
Pin assignment EPAD2:
1 RS-485 (A)
2 RS-485 (B)
3 Power supply (+)
4 GND
Pin assignment CPAD2:
1 CAN high
2 CAN low
3 Power supply (+)
4 GND
Schematic
4 pin LEMO series
connector
Programming information
The xPAD2-RTD8 programming information is available in the DEWE-MODULES Programmers Reference
Manual.
EPAD2/CPAD2-LA8-L1B Module