3 • Insertion Instructions | Stelo Glucose Biosensor User Guide 21
Avoid areas:
l
With loose skin or without enough fat to avoid muscles
and bones
l
That get bumped, pushed, or you lie on while sleeping
l
Within 3 inches of injection site
l
With irritations, scarring, tattoos, or lots of hair
To keep sensor attached see stelo.com/support.
2. Clean and dry site
a.
Wash hands with soap and water. Dry.
b.
Rub site with an alcohol wipe to get rid of all oils.
c.
Let dry completely so sensor will stick.
3. Unscrew cap
The applicator uses a needle to insert a tiny sensor wire
under your skin. The needle stays in the applicator, not
your skin.
l
Don't touch inside applicator
l
Don't use if damaged or previously opened
To Next Page
Loading...
