44
Extract Circuit
The Spin LED will illuminate at washer front and the washer controller PCB sends an extract signal to the
Variable frequency drive via the data cable at P6 to VFD RJ-11. The rotation as viewed from front during spin
will be CCW except 1816 twill BeCW. The motor is a 3 phase 230 VAC single speedtype motor .
Thermoactuator and Shake Out Circuit
The Lock Thermoactuator loses power and opens 1 1/2 minutes before the end of the cycle . This allows the
Thermoactuator time to retract by the end of the cycle.
To insure that the Lock Thermoactuator has retracted by the end of the cycle, 1 minute prior to the
end of the cycle, the Unlock Thermoactuator is powered with 115VAC through the org/red wire from P17 at
main relay PCB.
The basket will come to a stop from extract speed with the assistance of 2 dynamic braking resistors
wired in parallel to the variable freqency drive. The washer will then tumble for 45 seconds to let the clothes
shake loose and then stop.
End of Cycle Circuit
The machine is now stopped and does 2 things: 1. The beeper will signal for 5 seconds letting the user
know that it is the end of the cycle. 2. The micro-controlled PCB resets and display will reset when door is
opened and it is now ready to accept coins again.
Section 4
The following pages are a description of fault codes that will appear
on the front of the washer. There is a chart format that shows what
fault code that will be displayed at washer front.These codes dis-
played may stop machine operation or may not stop machine Please
check chart before removing power to reset.
PLEASE NOTE:CHECK DRIVE FAULT CODE BEFORE POW-
ERING MACHINE DOWN!
To Next Page
Loading...
Need help?
General
