61
Back Panel Removal
A. Remove all screws holding back panel in position except the bottom row.
B. The bottom row of screws are slotted and only need to be loosened and the panel will lift off.
Note: The back panel is not only a safety requirement but also contributes to the rigidity of
the cabinet.
Drive Belt Removal
Turn the drive belt(s) off the basket pulley first and then remove from the motor pulley.
Reverse this procedure for installation.
Note: Drive belts that should be replaced in pairs on models that require two belts.
Drive Motor
Refer to Specifications Chart for horse power and amperage draw on motors.
Removal
A. Remove the drive belt as explained above.
B. Remove the tension spring and bracket.
C. Disconnect the motor wires in the control area at the top of the machine. The motor wire
retaining clamp should be removed and reused. There is a diagram showing where each motor
wire plugs in so there is no need to mark them.
D. Loosen the set screws on the motor support shaft.
E. Remove the retaining bolt from the front of the support shaft.
F. Remove the motor support shaft.
G. Lift motor out of machine.
Note: On larger washers it is advisable to put a board under the motor and slide it out rather
than lifting it.
Control Panel Name Plate
The name plate on washer front is adhesive backed.
Removal
A. The name plate may be removed by simply peeling it off.
Installation
A. First remove the coin acceptor.
B. Remove any remaining glue from the control panel.
C. Before removing the paper backing from the name plate, check fit to the control panel. The
program push buttons and the coin acceptor opening are the locating guides.
D. Remove the paper backing from the right side of the name plate, position it on the panel and
press right end into place, then peel the backing from the left end and press into place.